A Complete Inspection ...
Dosil’s Underwater Services will perform a “complete inspection” on our initial visit to a pool losing water.
The divers inspection will include:
• Inspecting the Filter Area
Check all visible plumbing for leaks
Inspect valves, etc.
Make sure the “back wash“ line is closed
Check the ground for evidence of leaking
Make note of results
• Checking the Skimmers
Look for visible cracking
Dye test the skimmer rim area
Look for separations in the fixture
Make sure sealed plugs are in place
Epoxy if necessary
• Checking Step Area
Check for visible cracks
Dye test the seal between the steps and the liner
Dye test step jets and around the jet fixtures
Check the end of the screw cover molding for dye flow
(we do not remove the molding, with age it becomes too brittle)
Epoxy or patch if possible
• Inspecting the pool lighting
Dye test rim screws
Test area where rim flange meets the liner
Remove the light fixture and inspect light housing for leaks and cracks
Dye test the electrical conduit & fittings
Epoxy if needed

For Pools with Liners...
• Inspecting the liner for cuts and tears
Patch (up to 10) holes with vinyl liner material
(as close as possible to a pattern match. Liners fade , patterns go out of print, etc)
Liquid vinyl repair may be used on “pin holes”

For Concrete Pools…
• Inspecting pool for cracking
Repair cracks with epoxy
• Inspecting hydrostatic valve
Reseat the valve cap or replace if needed
(additional materials charge for a new valve)
• Checking relief plugs for leaking
Repair with epoxy

Reminder: A diver will only enter the pool if the water is clear, the pool is filled and the bottom is clean.